- Generic Com/TCP driver values rounded to the3rd decimal place - Dome light switch support added to ICSoverhead - ProSimDisplay: new option to add the foldername to the title bar - fix to prevent brake pressure to be negative - Fixed RED indicators handled as YELLOW - [SW-33] added Simworld Flight Controls module support - [SW-34] ILS-DME(Navigraph navaid type 8) navaids now correctly handled ifentered in CDU FIX page
- Sismo: Fixed servo daughter board not working
- Sismo: Fixed displays outputs(Display daughter board 2)
- new cockpit option to select alignment time (normal - quick)
- Master Dim gate added
- IOS Failures now organized by ATA chapter
- Fixed FDS JetMax radio assignments
- added cache control meta tags to IOS page
- added option to cockpit setup to remove the fading from weather radar sweep
- added option to cockpit setup to remove the interpolation(antialias) from theweather image
- [PSDB-310] Engine trend vector disapearing when target N1 value reached.
- [PSDB-326] Speedbrake stow not working below 10kts.
- [PSDB-328] Retractable landing lights switch not working correctly withCPFlight overhead.
- [SW-30] Simworld ATC panel delay fixed
- Added advanced option to CPFlight driver to disable the gauge data
- [PSDB-323] Fixed fuel filter failure to trigger an oil filter warning onEICAS
- Scavenge oil filter failure added
- [PSDB-335] Wiper switches and gates added.
- Wiper switch support added to CPFlight(ICS) and Simworld overhead and ProSimpanel.
- Fixed Side-by-side EICAS showing FF as KG even when unit is LBS
- Fixed Brake accumulator pressure to lock if pressure reaches 0
- Hydraulic system B should be the only pressure supplier to the brakeaccumulator.
- Fixed Pokeys Ethernet not working with poller disabled
- CPFlight advanced option added to reverse the rudder trim gauge
- Added support for FDS CDU v2 alternate layout
- [PSDB-182] EFIS POS now shows ADIRS and GPS positions on ND
|