- UID
- 2086
- 注册时间
- 2014-2-18
- 在线时间
- 小时
- 最后登录
- 1970-1-1
- 精华
- 阅读权限
- 100
- 听众
- 收听
|
发表于 2014-12-16 07:50:26
|
显示全部楼层
建议使用的Justflight补丁
1）启动刚刚安装飞行
2）选择的语言，点击下一步，你现在应该看到类似PIC＃1的屏幕
3）现在通过点击栏运行“只要飞行激活Patcher.exe”。
这是很简单的类似AEROSOFT补丁。如果事情已经过去了权将定位
文件修补，并告诉你它这样做关闭它在这一点上。
你需要把你选择语言和进度条移动之后的补丁按钮，
前主安装窗口打开。如果没有，你会得到一个错误消息说该文件不能被访问，因为
它是由另一个进程使用。这就是所谓的IO.File.Exception我没有代码捕获了异常，因为
只有少数用户会得到它。
4）继续运行安装程序时如PIC＃2的授权屏幕
出现输入任何一个电子邮件地址和密码，然后按登录。
你会得到一个消息，这是一个糟糕的电子邮件阿迪所以现在单击红色的X
在右上角的安装会告诉你这是要关闭。
关闭它。
5）现在，再次运行相同的JustFlight安装程序，它应该绕过
授权的屏幕和安装在飞机。
注意：
有时它会需要重新启动计算机，在安装结束
Advice for use the Justflight patcher
1) Start the Just Flight installer
2) Select the language, click next and you should now see a screen like Pic #1
3) Now run 'Just Flight Activation Patcher.exe' by clicking on the bar.
It's pretty straight forward similar to the Aerosoft patcher. If things have gone right it will locate
the file to patch and tell you it's done so close it at that point.
You need to push the button on the patcher right after you select Language and the progress bar is moving,
before the main installer window opens. If not you will get an error message saying the file can not be access because
it is in use by another process. It's called an IO.File.Exception which I did not code to trap that exception because
only a few users will get it.
4) Continue running the installer and when the authorize screen like Pic #2
comes up enter anything for an email address and password and press Login.
You will get a message that it is a bad email addy so now click the red X
in the top right corner and the install will tell you it is going to close.
Close it.
5) Now run the same JustFlight installer again and it should by-pass the
authorization screen and install the aircraft.
Note:
Sometime it will be needed to restart your PC at the end of installation
|
|
雷达卡
提升卡
置顶卡
沉默卡
喧嚣卡
变色卡
千斤顶
照妖镜
叫什么的那个小飞侠跑那去了 连个安装详细的都没有 还要金币 这不是坑人么
已绑定手机
